HLS System (Heel Lock Stabilizer)
The patent-pending HLS System eliminates skater’s heel slippage and dramatically increases skater’s control & comfort.

Rolled Top Comfort Collar
Provides the finest boot collar in the industry, increases skater comfort and eliminates lower leg irritation.

Anti-Rotational Tongue Lace Bar
Eliminates unwanted tongue rotation to enhance fit, comfort and support.

Ribbed Forefoot Flex
Enhances individualized fit allowing for comfort flex of the small toe and ball area of the boot.

Cork Heels & Midsoles
Dramatically reduces boot weight and provides for shock-absorbing landings. Require low maintenance.

Flex Notch Design
Improves individualized fit and forward boot flex without sacrificing lateral support.

Extended Open Throat Design
Wider lacing pattern provides for improved forefoot comfort and enhanced skating balance.

Heat Activated Reinforcements
All Riedell skating boots provide for heat activated individualized fit. Ultra sensitive heat activated reinforcement provides the ultimate in comfort and support. The following procedure should be used for maximum effectiveness of Riedell’s heat activated individualized fit features.

1. Properly measure for correct skate size.
2. Preheat warming oven to 200 degrees F.
3. Place open boots in oven for 8 minutes.
4. Remove boots from oven and flex back counters open.
5. Place on skater’s foot and tie boots extra snug.
6. Leave skates on skater for 5 minutes.
7. Remove skates from skater’s feet, allow skater to relax their feet, replace skates on skater using normal lacing pressure, and leave on skater for 2 minutes.
8. If a specific problem exists, remove skates; heat problem area with heat gun, adjust with boot press as needed.
9. Re-fit skates using normal lacing pressure.
10. Enjoy your new skates! Individualized heat activated fit complete.